GTSoundSim OBDII Engine Sounds

With GTSoundSim you can now get the supercar sound experience in any car, synchronised with your engine while you drive, thanks to a ELM327 Bluetooth OBD-II interface.IMPORTANT NOTE: This application requires an ELM327 compatible Bluetooth device to be connected to the cars OBD-II port in order to obtain real time engine data from your car.
These devices are inexpensive and readily available.
For example; http://www.amazon.co.uk/EiioX-ELM327-Interface-Bluetooth-Diagnostic/dp/B0098T6FZ8/ref=sr_1_9?ie=UTF8&qid=1432376888&sr=8-9&keywords=elm327
The app should also not be used whilst driving, To comply with road laws and for your own safety always stop before operating this application.
The android phone can then be connected to the car stereo system through the auxiliary cable, for a truly immersive experience.
The sounds are real sounds recorded from a range of super cars and performance race cars.
Sounds currently available within the application;• Lamborghini Aventador• Ferrari 458• BMW M3 GT2• Corvette ZR1• Renault Megane 225
In Dashboard mode the sound generated by the app will closely match the engine speed in real time.
There is also a manual test mode, to get a feel for the cars before setting off.
The sound generated is tailored to your car, you can select the RPM range of your engine and the app will automatically adjust the sound to provide the most realistic sound.
The performance of the app may be limited by the OBD-II interpreter speed or phone performance.
Therefore the applications performance may vary between configurations.
Instructions for use:
Welcome ScreenThis only shows the first time the app is run, this will guide you through the initial configuration of the application.
Dashboard ScreenIt is from here that the application can use the Bluetooth OBD-II device and car AUX cable to produce the real time engine sounds.
Successful connection to the OBD-II interface will be indicated by a ‘Connection Established’ message on the dashboard.

Pressing the start button will begin the engine sound synthesis.
If a connection cannot be established, confirm the device is paired and the engine is switched on, else the app may not be compatible with your device or vehicle.

Test modeBy selecting test mode you can test the application using the sliders for engine speed and engine load.
Pressing the Start/Stop button when running will end the engine sound generation.

Car Select ScreenTapping on the car image brings up the car selection screen, choose by swiping through the range available then clicking a particular car to load the sound.
SettingsParameters for the engine sound, and also the Bluetooth device can be found in the settings menu.